Awlgrip Cold Cure Primer Accelerator - M3066P

Awlgrip Cold Cure Primer Accelerator for 545 Epoxy Primer reduces cure and recoat times by as much as 50%. This can be extremely useful when spraying Awlgrip 545 Epoxy Primer in cooler temperatures.

Specifications:

• Type: Accelerator for 545 Primer
• Quantity: 1 pint
• Working temperature: 50° F - 75° F
• Recoating: at 77°F / 50% R.H Spray: 3 to 4 hours.
• Brush Roll: 8 - 12 hours. Maximum recommended amount of COLD CURE added
• VOC: 761 g/lt or 6.3 lbs./gal

Mixing:

• AwlGrip Cold Cure Accelerator can be added up to 12.5% of the mixed 545 base and converter.

Application:

• Mix by volume 545 Primer base with 1 part D3001 converter. Thoroughly mix the primer and allow the mixture to induct for 15 minutes. Remix after induction. Add Cold Cure to a max quantity of 12.5% by volume. Total mix by volume is 1:1:1/4.

Reducing:

• Reduction for Spray Application: Use T0006 reducer for additional reduction. 545 Primer is normally reduced 25% by volume. If the maximum quantity of Cold Cure is used, 1/4 part of T0006 is added to reach 25% reduction. Total mix by volume is: 1 part 545 base, 1 part D3001: 1/4 part M3066: 1/4 part T0006.
• Reduction for Brush Application: Additional reduction may not be needed after the addition of Cold Cure. If additional reduction is needed, use T0031 brushing reducer. The combined total of the M3066 and T0031 should not exceed 20% of the mixed base and converter.

Note: This multi-component system is intended for experienced painters. Please read mixing and application instructions thoroughly prior to starting project to ensure best results.

Safety Data Sheet