Egis Mobile Electric Automatic Charging Relay Plus - 7610-24

This 160A Egis automatic charging relay eliminates dead-start batteries by sharing charging on either of two batteries and isolating batteries when no charge sources are present.

Features:

• Accessible after mounting for programming voltage settings and determining active features. Protected by self-retained cover
• 100% non-ferrous corrosion-resistant materials. All attachment screws and nuts are self-locking
• Sealed Molex MX-150 connector eliminates the susceptibility to corrosion and vibrating loose of 1/4" quick connect terminals on competitive products
• Comes standard with a Deutsch DT/AT style connector harness. Provides three connection options (MX-150, DT/AT, and wire leads)
• Optional EasyLink bus bars reduce the space and cost of connecting TH Series relays with RT Series fuse blocks
• Indicates pending relay ON/OFF, under voltage, over voltage/temp, start isolation/assist, and output on/off status
• Ultra-low power draw compared to typical ACRs (7-10 mA) vs. the 7610 ACR @ 1.3 mA will not deplete batteries even after extended electrical system downtime
• Simple and robust installation - integrated sealed plug eliminates corrosion; includes Deutsch/Amphenol DTM connector harness
• Start to assist input option to ensure maximum cranking amps are available by allowing manually connecting batteries via a remote switch
• Bullet-proof construction - sealed unit, stainless steel hardware, and high-temperature materials allow mounting anywhere; Integrated thermal overload shutdown protection
• Additional low-amp output can be used to report device status remotely or drive a secondary relay for charge to a battery bank without a charge source

Specifications:

• Continuous Current: 160A
• Voltage Range: 16-36V DC
• Off-State Current Draw: 1.3 mA
• Interrupt Current: 240A
• AC Closing Voltage Range: 25.8-27.2V DC
• AC Opening Voltage Range: 24.2-25.6V DC

Guide (2.97 MB)