Egis Mobile Electric Programmable Automatic Charging Relay - 7610

This 160A Egis charging relay is automatic and programable. The relay eliminates dead start batteries by sharing charging on either of two batteries and isolating batteries when no charge sources are present.

Features:

• Accessible after mounting for programming voltage settings and determining active features
• 100% Non-ferrous corrosion-resistant materials. All attachment screws and nuts are self-locking
• Sealed Molex MX-150 connector eliminates the susceptibility to corrosion and vibrating loose of 1/4" quick connect terminals on competitive products
• Comes standard with a Deutsch DT/AT style connector harness. Provides three connection options (MX-150, DT/AT, and wire leads)
• Optional EasyLink bus bars reduce the space and cost of connecting TH Series relays with RT Series Fuse Blocks
• Provides an indication of pending relay ON/OFF, under voltage, over voltage/temp, start isolation/assist, and output on/off status
• Ultra-Low Power Draw Compared to typical ACRs (7-10 mA) vs 7610 ACR @ 1.3 mA, will not deplete batteries even after extended electrical system downtime
• Simple and robust installation - The integrated sealed plug eliminates corrosion and includes a Deutsch/Amphenol DTM connector harness
• Start Assist input option to ensure maximum cranking amps are available by allowing the manual connection of batteries via a remote switch
• Bullet-proof construction - Sealed unit, stainless steel hardware, and high-temperature materials allow mounting anywhere. Integrated thermal overload shutdown protection
• Additional low-amp output can be used to report device status remotely or drive a secondary relay for charging a battery bank without a charge source

Specifications:

• Continuous Current: 160A
• Voltage Range: 8-18V DC
• Off-State Current Draw: 1.3 mA
• Interrupt Current: 240A
• ACR Closing Voltage: 12.9-13.6V DC
• ACR Opening Voltage: 12.1-12.8V DC

Guide (1.75 MB)