Furuno Analog to NMEA 2000 Converter - IF-NMEAFI

This unit converts analog data from an external sensor to the CAN bus format data.

Only one sensor can be connected to an IF-NMEAFI at a time. The IF-NMEAFI outputs specific PGNs for the connected analog device.

The IF-NMEAFI can be configured for one of the analog devices by using a Furuno FI70 Data Repeater, TZtouch2, TZtouch3, TZTXL MFDs, or Suzuki SMD7/9/12/16 MFDs.

The IF-NMEAFI comes defaulted for use with a tank gauge. If using the IF-NMEAFI as a tank gauge, one of the devices listed above is required to set the parameters.

Using an FI70, TZtouch2/3/or XL MFD, the IF-NMEAFI can be configured to convert one of the following types of analog data to NMEA2000.

Features:

• FI5001/L Wind Sensor
• Tank gauge
• Water Temperature
• Water Speed

Installation Guide (1.24 MB)