Go Power Pre-Wired Transfer Switch - GP-TS

Go Power! Pre-Wired Transfer Switch allows both inverter and shore power to alternatively feed circuits.

Features :

• Two-pole 30 Amp AC Switch that automatically connects shore power (when available)
• If you unplug from shore power, it then connects your inverter output to power your circuits
• Includes a cable with built-in plug to connect the inverter output
• Includes a receptacle that powers your converter only when shore power is available

Installation:

1. Ensure the shore power plug is not connected to shore power and batteries are disconnected
2. Connect the RV shore power cord to Go Power! Transfer Switch input: wires are labeled "Shore Hot" and "Shore Neutral". Connect ground wire to provided ground bonding block
3. Connect transfer switch output to AC power panel. (Use terminals labeled "AC Panel")
4. Plug supplied inverter power cord into inverter. (With inverter power switch "off" or disconnect inverter from the battery.)
5. Plug Go Power! Battery Charger into transfer switch female outlet and connect to batteries. (When using a stock converter charger, remove the AC connections from the breaker panel and add a male plug to connect with the transfer switch female outlet.)
6. Disable converter when using a stand-alone charger