Icom M410BB Black Box VHF with Command Mic

Icom's M410BB is a flexible black box mounted on a fixed mount that provides VHF communications for vessels with limited helm space. The supplied CommandMic controls the radio for essential communications on the water.

Features:

• The M410BB consists of a CommandMic and a black box RF unit. Use the CommandMic for all operations, including DSC. Install the RF unit out-of-sight, placing it up to 60' (18.3 m) away from the CommandMic (2 OPC-1541 cables are required for the 60' installation, not included)
• Supports 1 additional CommandMic microphone
• On the back of every CommandMic is a conveniently located DSC button. Once triggered, the M410BB transmits a DSC alert signal to nearby vessels with the MMSI and GPS location of your vessel
• The NMEA 2000 network provides plug-and-play data communication to interconnect other marine equipment, such as an MFD (Multi-Function Display). The radio can send AIS, GNSS (GPS) position, DSC call, and radio channels to other equipment
• The built-in 15W amplifier increases the audio output of an external hailer speaker. The one-way RX hailer function enables you to broadcast radio traffic through the hailer speaker to listen to radio traffic on the deck or tower. You can also hear foghorn patterns from the hailer speaker
• The Active Noise cancellation function digitally removes background noise from transmitting and receiving audio to provide clear communications in noisy maritime environment
• AquaQuake function
• Anchor watch function

Specifications:

• Remote Stations: Up to 2
• Output Power: 25W
• GPS: Internal GPS GNSS Receiver, with external GPS antenna connection
• NMEA: NMEA 2000®/ NMEA 0183® -HS
• Waterproof Rating: IPX7
• Frequency Range: Tx - 156.025 157.425 MHz / Rx - 156.050 163.275 MHz / DSC - 156.525 MHz
• Usable Channels: USA, INT, CAN, WX channels
• Type of Emission: 16K0G3E (FM), 16K0G2B (DSC), 16K0GXW (AIS)
• Power Supply Requirement: 13.8V DC nominal (11.7 15.9V DC) (Negative ground)
• Current Drain (at 13.8V DC): TX Max. power - 5.5A Max. / RX Max. audio - 1.5A (One CommandMic) 4.0A (Two CommandMic and RX hailer)
• Antenna Impedance: 50 ohm nominal

Transmitter Specifications:

• Output Power (at 13.8V DC): 25 W, 1 W (high, low)
• Max. Frequency Deviation: +/- 5 kHz
• Frequency Tolerance: +/- 0.5 kHz
• Spurious Emissions: Less than –70 dBc (high power), Less than –56 dBc (low power)
• Residual Modulation: More than 40 dB
• Adjacent Channel Power: More than 70 dB

Receiver Specifications:

• Sensitivity: FM (at 12dB SINAD): 0.22 μV typical / DSC (at 1% BER): –7 dBμ emf typical
• Adjacent Channel Selectivity: FM - More than 70 dB / DSC (1% BER) - More than 73 dBµ emf
• Spurious Response: FM - More than 70 dB / DSC (1% BER) - More than 73 dBμ emf
• Intermodulation: FM - More than 75 dB / DSC (1% BER) - More than 68 dBµ emf
• Hum and Noise: More than 40 dB
• Audio Output Power: CommandMic - More than 2 W (4 ohm, 10% distortion) / Rx hailer - More than 15 W (4 ohm)

Included:

• DC power cable (2 m)
• DC Power Cable
• Microphone Hanger
• Connection cable, OPC-1540 (6.1 m, 20')
• CommandMic
• Connector cap
• Mounting base

Note: Images are for reference only. Only 1 CommandMic is included.

Product Brochure