Maretron Submersible Pressure Transducer - PTS-0-5PSI-01

Maretron PTS-0-5PSI-01 Submersible Pressure Transducers are designed for measuring tank fluid levels. This submersible pressure transducer is used for tanks up to 138.4" deep.

Features:

• Submersible pressure transducers are used together with Maretron's Fluid Pressure Monitor (FPM100 - Sold Separately), which allows tank fluid level to be broadcast over an NMEA A 2000® network where it can be monitored from any compatible NMEA 2000® display (Sold Separately)
• When used together with Maretron displays, alerts can be set so the user can be informed of low or high tank levels
• When not on-board the vessel, users can be notified through emails or text messages about their tank levels
• Additionally, the tank levels can be stored using Maretron's data recorder (VDR100 - Sold Separately) for later analysis

Specifications:

• Range: 0 to 5 PSI
• Depth: 138.4" (3.52 m) water
• Cable Length: 23.0' (7 m)
• Sensor Type: Gauge (Vent Tube)
• Output: 4 – 20 mA current loop, loop powered
• Excitation Voltage: 9V DC to 32V DC
• Compatible Fluids / Gases: Motor Oil, Diesel, Hydraulic Fluid, Water, Waste Water
• Operating Temperature: 14° F to 158° F (- 10° C to 7 0 ° C)
• Ambient Temperature: 14° F to 158° F (- 1 0° C to 7 0 ° C)
• Accuracy: ±0.3% Full Scale typ. at 25° C
• Total Error Band (TEB): ±1.0% Full Scale typ. (- 10° C to 70° C)
• Non - Linearity, Hysteresis (NLH): ±0.2% Full Scale typ. Best Straight Line (BSL) at 25° C
• Temperature Compensation Zero Point and Span: 0.04% Full Scale/° F (0. 02% Full Scale /° C)
• Long Term Stability: 0. 2% Full Scale typ. 1 year at 25° C
• Rise Time: 1 ms typ. (10% - 90% nominal pressure)
• Switch - On Delay: 100 ms
• Over Pressure: 15 PSI (1.03 bar)
• Burst Pressure: 30 PSI (2.07 bar)
• Vibration: 6 g (25 to 2000 Hz)
• Shock: 50 g / 8 ms
• Construction: AISI316L stainless steel housing, pressure connection; Ceramic, Al 2 O 3 (96%) Sensor; FKM (FPM, Viton), EPDM (TPE) seals; PUR cable
• Minimum Cable Bend Radius: 1.57" (40 mm)
• EMC Compatibility: EN/IEC 61000 - 6 - 3 / GL 2012, IV, Part 7 (Emission and Immunity)

Important Note: Maretron pressure transducers are not approved for use with gasoline. If you wish to use the FPM100 to monitor pressures or levels of gasoline, you must obtain a pressure transducer that is approved for use with gasoline

Installation Instructions