Nauta Heavy Duty Holding/Diesel Fuel Tank

These Nauta tanks can be used as Holding tanks or Diesel Fuel tanks. They are not intended for use with gasoline and do not include fittings - fittings are required and can be purchased separately. The size and type of fittings should be determined by your use of the tank. You can purchase, locate and install the fittings according to your needs.

Diesel Fuel Storage Tank: Nauta flexible diesel tanks can dramatically extend the range of powered sail and motor boats. They can be deck or cockpit mounted to gravity feed (or be hand-pumped) to tankage below decks. And, when empty, these tanks can be rolled up and stowed. Sport and commercial fishermen heading into offshore waters and cruisers visiting remote ports (where refueling may be unavailable or of suspect quality) will find these Nauta tanks an ideal, low cost solution.

Waste Storage Holding Tank: The more rigorously enforced laws against overboard discharge now make non-compliance extremely costly. A Nauta flexible holding tank, on the other hand, provides a relatively inexpensive Type III solution. In addition, the Teldar™ lining of these Nauta tanks prevents gas permeation, thus stopping a major odor problem associated with many other holding tanks. Combined with a few other components, this solution is both legal and far less costly than re-plumbing a vessel or installing a more complex and expensive Type I or Type II system. These tanks occupy less space and requires no electrical power.

Features:

• 935-Dtex nylon fabric tank material
  • Coated on both sides with a neoprene/nitrile compound
• Heavily lapped seams are inside-reinforced with a "doubler" to provide extra strength
• Vulcanized to assure leak proof panels and seams for years of trouble-free service
• Can fit into almost any space, especially those odd-shaped places that would otherwise be wasted
• Factory installed center cleanout fitting with threaded cap does not accept any standard fittings
• Spanner wrench (FTP010) is included with this tank and is designed for fitting installation, removal and relocation
• Flat dimensions (for empty tanks):
  • FT915120 - 14.5 Gal (27" x 25")
  • FT915150 - 25 Gal (27" x 34")
  • FT915160 - 37 Gal (27" x 46")
  • FT915180 - 52.5 Gal (27" x 63")
• Warranty: 1 Year

Note: Does not include required fittings (fittings can be purchased separately)