Propspeed Propeller and Running Gear Coating System

PropSpeed foul-release coating is specially formulated to keep running gear and any other underwater metals, free of marine growth and protected against corrosion.

Features:

• Long-lasting, ultra-smooth, integrated foul release system
• Dramatically reduces the ability for fouling to occur
• Designed to increase vessel speed and fuel efficiency
• Environmentally friendly so it doesn't harm marine life - contains no tin, copper, biocides, or anti-slime additives
• Exceptionally strong chemical and physical bond between the metal substrate, primer, and top coat ensures the coating will stay on your running gear
• Reduces corrosion and lowers maintenance costs
• PropSpeed's effectiveness does depend on movement of your boat - the more you use it, the better PropSpeed performs
• May be applied to any metal part below the waterline, including propellers, shafts, struts, rudders, trim tabs and through-hull fittings
• Safe for use on aluminum components
• Clear coat can also be applied directly to plastic bow-thruster propellers and underwater light lenses
• Safe to haul out boat for maintenance or winter storage but be sure not to pressure wash coated gear
• Multiple kit sizes available. Perfect for DIY boaters and marine trade professionals alike
  • Propclean ensures that the metal surface is completely free of contaminants and ready for Propprep
  • Propprep is critical in the chemical preparation of the metal surface to be coated
  • Etching Primer base and Etching Primer hardener combine to create tenacious adhesion and corrosion resistance
  • Clear Coat forms a slick outer layer that marine growth cannot adhere to

Specifications:

• Color: Yellow
• Coverage:
  • Small Kit: 0.7 m²
  • Medium Kit: 1.7 m²
  • Large: 3.4 m²
• The running gear temperature must be a minimum of 59° F or 15° C and continue to be at least that temperature during the process of application
• Application temperature is for running gear, NOT ambient temperature
• Temperature and time windows are critical for proper adhesion and protection
• Application stages:
  • Metal surface preparation: Sanding the surface or using PropStrip
  • Initial cleaning using PropClean
  • Metal conditioning using PropPrep
  • Applying Metal etching primer
  • Applying clear coat top coat
• A minimum of eight hours drying time is required after final coat at 59° F
• If the running gear temperature is below 59° F or 15°C, a minimum of 24 hour curing time is recommended
• Be sure to watch video and read complete instructions prior to application

Kit Overview and Introduction

Quick Application Guide

Safety Data Sheet