Victron Energy Phoenix Smart IP43 Charger

With boat owners in mind, this adaptive 5-step charger can provide a charge to battery banks. Bluetooth enabled, you can monitor the charger and set alarms straight from your phone.

Features:

• Bluetooth Smart built-in - set up, monitor, update and synchronize Phoenix Smart IP43 Chargers
• Phoenix Smart (1+1): two outputs to charge 2 battery banks - the second output, limited to approximately 4A and with a slightly lower output voltage, is intended to top up a starter battery
• Phoenix Smart (3): three full current outputs to charge 3 battery banks - each output can supply the full rated output current
• Compensates for voltage drop over the DC cabling by slightly increasing output voltage when the DC current increases
• Adaptive 6-stage charge algorithm: bulk - absorption - recondition - float - storage - refresh
  • 'Adaptive' battery management system can be preset to suit different types of batteries
  • Automatically optimizes the charging process relative to the way the battery is being used
• BatterySafe mode - the charger will prevent damage due to excessive gassing by automatically limiting the rate of voltage increase once the gassing voltage has been reached
• Storage Mode kicks in whenever the battery has not been subjected to discharge for 24 hours
  • In the Storage Mode, float voltage is reduced to 2.2V/cell (13.2V for a 12V battery) to minimize gassing and corrosion of the positive plates
  • Once a week the voltage is raised back to the absorption level to 'equalize' the battery
• Charges Li-ion (LiFePO4) batteries by connecting a relay or open collector optocoupler output from a Li-ion BMS to the remote on-off port
• Fully programmable charge algorithm
• A Smart Battery Sense or a BMV-712 Smart Battery Monitor can be used to communicate battery voltage and temperature to one or more Phoenix Smart IP43 Chargers
• Remote on-off switch or relay contact can be connected between H and L - alternatively, terminal H can be pulled high, or terminal L can be pulled low
• VE.Direct interface for a wired data connection to a Color Control panel, PC, or other devices
• May be programmed using the VE.Direct interface or a Bluetooth-enabled device to trip on an alarm or other events
• Pair two or more Phoenix Smart IP43 Chargers in a VE.Smart Network to improve the charge efficiency and battery life

Note: Requires 5-15P mains cord

Datasheet