Designed for cruising yachts or commercial vessels, the Raymarine Follow-On Tiller is a simple add-on control unit that brings fully functional power steering to remote and secondary control stations anywhere onboard.

Features:

• Designed for cruising yachts or commercial vessels
• With a single button press, the tiller activates Evolution's Power Steer mode, enabling captains to send precise steering angle commands to the rudder, up to 35°
• Can be installed at bridge wing stations, aft docking stations, or even into the arms of pilothouse helm chairs
• Designed for surface mount installation into any flat, rigid surface - fully waterproof for above or below-decks mounting
• Up to (4) Follow-On Tillers can be installed onboard the vessel enabling control from multiple locations
• Simple installation with standard SeaTalk ^ng or NMEA2000 connectivity
• Setup and calibration performed using the system's primary autopilot control head or autopilot-enabled LightHouse 2 or LightHouse 3 Multifunction Display
• Supports both proportional (Full Follow-Up) and bang-bang (Non-Follow-Up) modes for maximum flexibility
  • The controller comes pre-fitted with a return spring to bring the controller back to the 0° center position automatically upon release
  • The return spring can be removed if desired
• In proportional mode, the rudder follows the tiller precisely, degree for degree, and the rudder returns to amidships whenever the tiller is in its center 0° position
• In bang-bang mode, the amount of deflection of the tiller controls the speed of rudder travel in the direction signaled
• Moving the tiller to the center 0° position stops the rudder immediately in position
• The operator must always manually drive the rudder back to amidships in bang-bang mode
• Applications: Raymarine Evolution Autopilot Systems installed on powerboats only

Specifications:

• Steering angle: +/- 35 degrees
• Mounting option: Surface mount
• Environment: Above deck to IPX6 and IPX7
• Power Supply: 12V DC Via SeaTalk ^ng
• Current Consumption: 30mA (1 LEN)
• Housing: Front, anodized front panel, with rubberized keypad
• Temperature: Operating -25° C to +55° C. Storage temperature -30° C to +70° C
• Dimensions: 55 mm (Width) x 133 mm (Length) x 13 mm (Height above mounting surface) / 20.4 mm (Height below mounting surface) - Arm length 79.6 mm

In the Box:

• Follow On Tiller Controller
• Keymat
• Outer Bezel
• 1 meter ST ^NG interconnect cable (A06080)
• Mounting Hardware
• Rotary Lever Installation Guide and Documentation kit

Installation Instructions