The Quantum 2 next generation CHIRP pulse compression radar by Raymarine provides superior target awareness at both long and extremely short ranges with Doppler collision avoidance technology.

Features:

• Doppler moving target display allows for superior situational awareness at-a-glance
• Fully automatic ARPA (automatic radar plotting aid) target tracking, along with manual MARPA (mini-automatic radar plotting aid) mode
• CHIRP Pulse Compression detects contacts as close as 18-feet for zero-visibility navigation
• 24-mile range for early detection of traffic, navigation aids, landfall and weather
• Immediate awareness: Quantum starts up and is ready to go in seconds
• Superior interference rejection eliminates noise from other radars
• Easy upgrade: Quantum 2 fits the same bolt pattern as other Raymarine scanners
• Lightweight and easy to install: Quantum weighs up to 50% less than comparable magnetron radars
• Safe emissions: Mount Quantum anywhere onboard
• Low power consumption for extended battery life when under sail or not running an engine or generator
• The Quantum 2 also features fully automatic target acquisition and tracking, calculating course, speed, closest point of approach and more
• Configure custom sa fety or alarm zones and be alerted to new radar contacts entering the zone
• You'll be alerted to dangerous contacts with audible alerts and easy-to-understand on-screen graphics
• Quantum 2 also features Raymarine's new True Trails target history display
  • The True Trails feature enables you to see a historical "wake" behind every moving contact
  • The Trail makes it even easier to interpret the motion of other vessels, allowing you to make smart maneuvering decisions to pass safely
• Quantum 2 with Doppler can be installed in a traditional wired configuration, or use its built-in Wi-Fi technology to connect it to your Raymarine MFD

Specifications:

• Diameter: 541 mm (21.3")
• Height: 209.5 mm (8.25")
• Supply voltage: 12V DC or 24V DC nominal
  • Minimum: 10.8V DC
  • Maximum: 31.2V DC
• Power consumption:
  • Transmit mode (maximum): 17W
  • Standby mode: 7W
  • Sleep mode (applies only to radars connected via Wi-Fi): 2W
• Waterproofing: IPX6
• Operating temperature range: -10° C to +55° C
• Storage temperature range: -25° C to +70° C
• Additional storage conditions: Store upright; do not block vents on underside
• Humidity: Up to 95% at 35° C
• Maximum wind speed: 100 knots
• Transmitter:
  • Type: X-band solid-state transmitter with pulse compression technology
  • Transmit frequency: 9354 MHz to 9446 MHz
  • Peak power output: 20W
  • Duplexer: Circulator Pulse widths (3 dB): 40 ns to 14.7
  • Chirp lengths: Chirp lengths: 400 ns to
  • Pulse repetition frequency: 2083 Hz
  • Chirp bandwidth: Up to 32 MHz
  • Standby mode:
    • Scanner rotation - OFF
    • Scanner transmission - OFF | Wi-Fi link - ON
• Antenna:
  • Type: Patch array
  • Beamwidth (nominal):
    • Horizontal: 4.9°
    • Vertical: 20°
• Polarization:
  • Horizontal Rotation speed: 24 rpm nominal
• Doppler:
  • Target Tracking: Tracking of (10) simultaneous MARPA and / or ARPA targets (with Doppler-assisted ARPA)
  • Target Filtering: True Motion mode identifies only those objects that are moving relative to the vessel

In the Box:

• Raymarine Quantum Q24D Doppler Radome
• M8 mounting bolts with spring washers and flat washers
• Documentation pack (including mounting template)
• Power cable - not included in E70498 (without cables option)
• Data cable - not included in E70498 (without cables option)

Raymarine Quantum 2 Installation Instructions (3.82 MB)