Spectra Watermakers Ventura 150D Watermaker with Analog Control Panel - VT-150-D-12V

Package Includes:

• High Pressure Clark Pump and Reverse Osmosis Membrane Module
• Analog Gauge Assembly
• Inlet Feed Pump Module with Fresh Water Flush System
• Accumulator Tank
• Manual
• Installation Fittings Kit
• 5/8" Hose (2 x 25')
• Service Kit

The Spectra Ventura VT-150-D Desalinator is engineered for smaller vessels to be energy-efficient and lightweight. The compact, modular design, makes for easy installation in confined spaces. The Ventura 150 operates anywhere in the world and delivers more than 6 gallons (24 liters) an hour. This system has analog controls with an instrument panel containing a feed water pressure gauge and a product flow meter.

Features:

• Spectra Ventura VT-150-D Desalinator includes installation kit with handheld salinity meter and a water sampling valve
• Designed to work in all water temps for efficient operation from the Arctic to the Equator
• Commercial-grade diaphragm pumps with run-dry protection
• Low power consumption; can be run on batteries, solar or wind power
• Whisper quiet
• Compatible with Spectra's Z±Ion system (sold separately)
  • Protects membrane, filters on your Spectra watermaker

Specifications:

• Fresh water production:
  • 6.3 Gallons (24 liters) per hour
  • 150 Gallons (568 liters) per day
• 9A @ 12V DC
• Power Consumption:
  • 17W per gallon
  • 4.5W per liter
• Pre Filters: 2.5"x10 " pleated polyester 5 micron
• Controls: Analog controls
• Installation Requirements: Dedicated thru hull, dry and well ventilated area not to exceed 110 F / 37C (Sold Separately)
• Membranes: 20" x 2.5" High rejection spiral wound polyamide
• Pump and Motor: Shurflo diaphragm pump
• Salt Rejection: 99.2 %
• Temperature Range:
  • Maximum 110 degrees F / 37 degrees C
  • Minimum 36 degrees F / 2 degrees C
• Baseline Conditions: 33,000 PPM feed water at 77 degrees F / 25 degrees C
• pH Range: 3-11 (typical seawater pH is 8)
• Chlorine Tolerance: 0 PPM
• Warranty: Spectra standard warranty

Note: The system must be connected to a dedicated 1/2" to 3/4" forward facing scoop type intake, thru-hull and seacock. A brine discharge thru-hull should be above the waterline, along or just above the boot stripe, to minimize water lift and back pressure. (Thru-hulls sold separately)

Specifications Brochure

Owner's Manual and Installation Guide (3.79 MB)