Lenco Digital Auto Glide Kit without GPS Antenna or Network - Dual Actuator - 15505-101

Features:

• The Lenco Auto Glide Kit offers real Automatic Boat Control / Trim Tab Control System that actually works – completely & automatically
• The Auto Glide system controls your trim tabs from the time you leave your dock until you come home again
• The Auto Glide uses engine data and GPS data (depending on your installation method) to drive your boat to the most efficient running angle by adjusting your Lenco trim tabs as needed
• This optimum running angle is determined during the set-up process after the installation of your Auto Glide system
• Imagine that your boat's running angle is measured 25 times per second
• This data is used by the new Auto Glide control box to:
• Automatically put your boat in the most efficient running angle
• Reduce the amount of bow rise of your boat during hole shot mode
• Eliminate bow porpoising (bow bounce)
• Keep your boat level at all times
• These actions will result in a smoother ride and the best possible fuel efficiency
• Please remember to use the trim feature exactly as you would in the normal operation of your boat
• The Auto Glide Control Box (brain) consists of gyroscopes, accelerometers, and new, very sophisticated, and patented software
• The Auto Glide has (3) automatic operational modes, (4) automatic settings, and (2) manual operational modes
• Although you will most likely keep your Auto Glide in automatic mode, you may immediately convert to manual mode simply by pressing one of the (4) Up/Down buttons on the key pad
• All of these functions are fully explained in Lenco's Owner's Manual B / Operational Instructions (See Below)

Components of the Auto Glide System:

• The main components are the Auto Glide Key Pad, the Auto Glide Control Box (Double Actuator per Trim Tab Versions), the Control Box Main Harness (same 2 versions), and various cables
• These cables connect the Auto Glide system to your engine(s), to your GPS unit, your network, and/or a Stand Alone GPS Antenna/Receiver

What is required for the Auto Glide to work on my boat?

• Boat must have Lenco Dual Trim Tab System with Lenco Electric Actuators
• This is a MUST in all applications
• For Aftermarket Systems:
• The Lenco Glide System will work on ALL boats with ALL engines
• GPS data is used to provide data to control box
• Optional connection to NMEA 2000 Network is included
• Available for these CANbus-based engines:
• NMEA2000 Engines
• Yamaha (Command Link Plus requires NMEA 2000 / Yamaha Gateway P/N:6Y98A2D00000)
• Evinrude
• Honda
• Suzuki
• Volvo Penta (Non-EVC Engines) (With a Volvo NMEA2000 Gateway - Volvo P/N 3889757)
• J1939 Engines
• Volvo Penta (EVC Engines)
• Yanmar
• Caterpillar
• Cummins Detroit
• Diesel
• John Deere
• Steyr
• SmartCraft Engines
• Mercury - Verado
• Mercury - Optimax with SmartCraft ECU
• Mercruiser with SmartCraft ECU
• Cummins/Mercruiser w/ SmartCraft ECU

Options and Accessories (Available by Special Order):

• Second Station Kits and a vast array of other accessories and parts which may be required for your installation are also available
• Lenco offers Aftermarket Kits for easy installation on ALL boats, CANbus-equipped or not

Note: The Auto Glide does not control the "trim" function of your engine(s) / motor(s)

Owner's Manual A

Owner's Manual B